Coconut Flooring

From CoconutFlooring1

From CoconutFlooring1

From CoconutFlooring1

EXOTIC PALM is our latest product that made from long and slender strands of palmwood. Like a fabric woven with many fibers for extra strength, the recomposed effect is incredibly durable and stable. It has a greater hardness and density than natural hardwood.

EXOTIC PALM has the unparalleled appearance texture and grain. We can produce two styles, namely recomposed palmwood flooring and recomposed palmwood/bamboo mixed flooring.
Advantages:
1. Hard surface, peculiar style, keep new after years of usage;
2. Anti-friction and anti-scratch, Solid enough to bear pressure without trace;
3. High-density, anti-fire layer, Waterproof and fireproof surface;
4. Keep color un-faded for a long period, decorating surface with anti-ultraviolet radiation and anti-light, keep colors unchanged;
5. Simple maintenance, lightly erase stain;
6. Anti-chemicals, anti-chemical corrosion;
7. Simple and clean layingWE WELCOME ALL INQUIRIES.

WE ARE LOOKING FOR DISTRIBUTORS IN ALL COUNTRIES

It is recommended that the industry standard of 5-10 percent be added to the actual footage of required flooring materials as an allowance for cutting and waste during installation.
Installation of a factory-finished hardwood floor requires more care than a conventional floor to prevent damaging the floor’s finish during installation. Frequent use of a vacuum cleaner during installation is highly recommended to eliminate sawdust and wood chips.
A sharp, fine-tooth (finishing) circular/miter saw blade is recommended for cutting. Taping the area to be cut makes for a cleaner cut.
Always use a tapping block and never hit flooring directly to avoid fracturing the flooring edge. A small piece of your flooring makes a good tapping block.
Nails and staples are best placed at least three inches from the edge of the boards. For wood sub-floors, nail every six inches.
It is recommended that door casings be cut at the bottom so flooring will fit under it instead of scribing the flooring to fit around the door jambs.
Leave approximately a ½ inch space at each wall for expansion of flooring. The expansion gap can be covered with some base molding.
Take care of moisture problems or potential problems BEFORE installation. Special precautions should be taken below grade. A vapor barrier or flooring paper placed between the sub-floor and the boards will help keep the humidity content of the flooring more stable. If your bamboo flooring installation is hampered by a moisture problem, contact a professional installer to improve the situation. A calcium chloride test should be performed on any conrete flooring before installation occurs.
To avoid a pattern of end joints, cut the initial boards in each row at varying lengths so that all the board ends are staggered throughout the installation. Ensure that the joints are at least six inches apart.
Before installing, lay out the flooring in a rough fashion according to how you would like it to appear. Arrange the bamboo’s natural range of color in a manner that is pleasing to your eye. Remember, as noted before, like other natural products, some color variation is expected in bamboo flooring.
Slightly bent or bowed boards are not defective. These boards may be a little harder to install, but they will lie flat after installation.
Use pull straps at three-foot intervals to hold the boards firmly together while installing. You could also use wide masking tape.
For adhesive installation, use a 100% urethane-based adhesive such as Bostick’s Best. Be sure to follow Bostick Findley’s instructions so their warranty is in effect.